產品（pǐn）範圍

　　供熱量：（1200-1600）×104Kcal/h，設計壓力：1.1-1.6MPa

 　　燃煤（méi）導生鍋爐為組裝式強製循環液相鍋爐。本係列鍋爐應用於供熱溫度390℃化工企業，針對導生（聯苯-聯苯醚）的特點，按照低（dī）點排淨（jìng）、高點放空進行設（shè）計，受熱麵充足，由輻射受熱的密排方形（xíng）盤管和錯列（liè）設計（jì）的對流蛇管組成。導生鍋爐尾部布置餘熱蒸汽鍋爐和空氣預熱器，可（kě）降（jiàng）低排煙溫度，提高係統效率。

　　為提高鍋爐的an全性，材料選用耐熱合金剛管材，對接采用100%射線探傷，角（jiǎo）焊采用100%表麵探傷。

　　采用水冷（lěng）前後（hòu）拱，降低停電後爐牆蓄熱，保護前後拱的使用壽命。

　　采用PLC控製技術和變頻（pín）器調節，使出口導（dǎo）生溫度控製在設定溫度±1℃範圍內

　　Product Range

　　Heat supply: (1200-1600) × 104Kcal / h, design pressure: 1.1-1.6MPa

　　Coal-fired boiler is an assembled forced circulation liquid-phase boiler. This series of boilers is used in chemical companies with a heating temperature of 390°C. According to the characteristics of the introduction (biphenyl-diphenyl ether), the design is based on low-rank discharge and high-point venting. The heat-absorbing surface is dense and the radiation-heated dense square is adopted. Coil coil and staggered design of the composition of the coil. 

　　The exhaust steam boiler and air preheater at the tail end of the induction boiler can reduce the exhaust temperature and improve the system efficiency.

　　In order to improve the safety of the boiler, the material is made of heat resistant alloy rigid pipe, 100% ray detection for butt joints and 100% surface inspection for fillet welds.

　　Water cooling before and after the arch, reducing the power failure after the furnace wall heat storage, arch protection before and after service life.

　　Using PLC control technology and frequency converter adjustment to control the exiting temperature of the outlet within the set temperature range of ±1°C